CP Seal Height Rod slide" This is one of the

This is one of the most commonly used sensors on all Evolution Series

The Can a Index Exit Sensors are used on Wild Goose Filling WG8/10 canning lines only and are used to detect the presence of cans as they exit the seamer

This sensor cable supplies power to the Lid Present in Chute Sensor and sends a signal back to the machine's PLC

It has a molded straight M12x1 threaded male connection on one end and a snap-locking RJ45 plug on the other

PBT and nickel-plated brass

CP Seal Height Rod slide" This is one of theThe CP Seal Height Rod (AKA Tapped Linear Motion Shaft) is used on all Fusion Counter Pressure systems and is used to guide the Fill Head Raise Plate as it moves up and down. All are turned, ground, and polished to tight diameter and straightness tolerances. The surface is hardened, so they stand up to repeated motion while keeping their center soft enough to absorb stress from shifting loads. Chamfered edges remove sharp corners at the end of these